Don't see a fixture plate for your machine on our site? Our Fixture Plate Compatibility Checker allows you to easily check the fit of an existing fixture plate in our product line on your machine table! If you still don't see a compatible fixture plate, feel free to reach out via our Custom Fixture Plate RFQ form.
1. Enter the center-to-center t-slot distance
T-Slot Spacing:
Number of Slots:
Note: Fitment is determined by comparing Dimension B to the input slot spacing. Compatible plates shown may also have a Dimension B which is a multiple of the input spacing.
2. Distance from the rear edge of machine table to the center of the rearmost t-slot
Compare this measurement to Dimension A given on the SMW Fixture Plate. If Dimension A is greater than your measurement, the SMW Fixture Plate will overhang the rear of the machine table. Please verify that this overhang is acceptable before purchasing and installing an SMW Fixture Plate.
3. Verify horizontal mounting hole distance
Confirm that Dimension C is less than the overall length of your machine's t-slots. Note that for sets of plates, Dimension C is for a single plate.
4. Verify with Solid Model
Verify the final fitment on your machine by downloading the solid model from the plate's product page and placing it on your machine table.
Note: SMW cannot guarantee fitment for your machine with this tool alone. This tool is meant for reference only, and verifying fitment using provided solid models is highly recommended. Hardware included with certain plates may not be the correct fit for your specific table.